CITB / CPCS A31 Ride on Roller
|
Basic Training 3 Days
This is for candidates with little or no experience in operations of a Ride on Roller. Upon completion candidates will have shown a knowledge and understanding of:
Carrying out pre start and running checks on machine
Set the roller for site travel
Travel over differing types of terrain, including undulating ground
Manoeuvre in confined areas using forward & reverse direction
Set the roller for compaction duties
Compact different materials to requirements
Compact up to supported & unsupported edges, against a radii
Place machine in and out of service condition
Explain loading and unloading procedures on & off a transporter
Upon completion of 3 day course an Intermediate Construction award will be issued for Training and candidates can then go forward for CPCS Technical Test.
Experienced operator(s)
For experienced operators familiar with operations of Ride on Rollers we offer a 1 day formal training section prior to test to brush up on any bad habits that may have been picked up over the years.
Upon completion of a 1 day course an Intermediate Construction award will be issued for training and candidates can then go forward for CPCS Technical Test.
CPCS Technical Test
Theory test - A recorded oral questioning session of up to 1hr 15 min duration and candidates must pass this test before any practical test is undertaken.
Practical test - A timed category specific practical test for Ride on Roller the time allowed is 1hr 15min.
Only upon completion of technical test can CPCS 'Trained Operator' card be applied for.
Location
Courses are held at our Training Centre in Corfe Mullen, which is easily accessible for the whole of the South of England being just off the A31. Alternatively, we can deliver training on clients sites, subject to minimum requirements as laid down by the CITB /CPCS scheme.
|
